Week 6

Summary

Written by Trumann (24 Dec 2021)

What was done this week

Group A's progress

Following up from Week 5, leak locations previously identified were further reinforced using the sealant glue. A make-shift glue applicator made from a wire and bolt was used to allow for more precise application of glue after learning from the first prototype where the glue stains were obvious. 

Figure 1: Using a make-shift glue applicator to apply sealant glue

Other parts like the pipes, valves and electrodes with its holder were installed. Pipes needed to be glued with the sealant glue to ensure that no leaks appear. The glue was left to dry for about 2 hours to allow it to solidify but not settle down and become water-proof. This meant that the leak test could had to be done on an alternate day. 

A mini photoshoot was done to obtain feedback from the project supervisor. 

Frosted Background with phone light to emulate the sun

“Natural” Background